32
To adjust screen door
1. Lift the screen and the glass door completely to the top.
2. Unscrew one of the two bolts (A) which are located on the lower right of the screen door
(See Figure 29).
3. Slightly unscrew the other bolt to allow the door adjustment.
4. Move down the screen door to the bottom.
5. To adjust, move the door to the left or right as needed.
6. Without changing the performed adjustment, move up about 6” the screen door.
7. Tighten the 2 bolts.
Figure 29
4.0 Venting System (Chimney and Chimney Connector)
4.1 General
The venting system is the engine that drives your wood heating system. Even the best
fireplace will not function safely and efficiently as intended if not connected to a suitable
chimney.
The heat in the flue gases that pass from the fireplace to the chimney is not wasted heat. This
heat is what the chimney uses to make the draft that draws in combustion air and keeps the
combustion gases within the fireplace. You can think of heat in the flue gas as the fuel the
chimney uses to make draft.
Summary of Contents for FP-7-LM ANTOINETTE
