Service manual
31
error message
possible causes
how to solve the problem
number of lines
in printing mode
"continuous labels" number
of lines too low
correct number of lines
interface protocol
incorrect setting of SOH
and ETB
change interface protocol
ribbon or
print head error
no transfer ribbon
print head not closed
load transfer ribbon
close print head
no cutter available
print mode "Cutter OFF" or
connect cutter
cutter
cutter will not be switched
off (cutter photocell or
micro-switch are defective)
Please contact your
distributor.
power failure
please wait
loss of voltage supply
check power line and
surroundings
no RTC installed
no RTC ram
add RTC ram
RTC-mode
RTC entry incorrect
check RTC entry and
change
RTC-format string
RTC format string faulty
check RTC format string
and change
dispenser photocell
defect or not connected
dispenser photocell
defective
dispenser photocell not
connected
exchange dispenser
photocell
connect photocell