26
Troubleshooting
Problem
Cause
Solution
Seems dead, no
display or audio.
No power.
1. Check power-cord connections.
Check fuse in Lighter Adapter
(Is it in place? Is it blown?).
See page 9 in Owner’s Manual.
2. Check contact of Adapter in
lighter socket.
3. Make sure power is available at
lighter socket. Does the lighter
work? If not, check fuse in car
lighter circuit.
4. Try another power cord.
5. Make sure the power cord to V1
Gen2 is plugged into the Main
jack of the Lighter Adapter.
6. Check pins of V1 Gen2’s power
jack (bent?).
1. Try different connecting
cords; each must have four
conductors.
1. Make sure Lighter Adapter has
good electrical contact.
2. Check condition of power cord.
3. Lighter socket may be faulty
(common in rental cars).
1. See your mechanic.
1. Make sure front and rear
antennas are unobstructed.
2. Make sure V1 Gen2 is
approximately level.
3. See page 28 in Owner’s
Manual.
1. Switch the V1 Gen2 off and
back on.
2. Contact the service department
if the display persists.
Concealed Display
seems dead.
No communication
with V1 Gen2.
Sounds the power-on
audio when you go
over a bump.
Bad power
connection.
Alerts when you use
vehicle accessories,
turn signals, brakes, etc.
Electrical problem
in your car.
Weak or no radar
detection.
Possible installation
problem.
Display shows an
error ( ).
Internal Error
Summary of Contents for V1 Gen2
Page 1: ...OWNER S MANUAL With exclusive Analyzer Modes All Bogeys Logic Advanced Logic powered...
Page 2: ......
Page 39: ......
