OMNIA
39
While positioning the material pay
attention to:
- the side with a width between 200 and
340 mm, touches the front of the feeder.
- the left side touches the reference plate
(Point 0 nr. 2).
Place a movable stop on the right and back
side to keep material aligned.
Warning:
As we previously did, make sure
to do not position the movable stops
beyond the line drawn on the surface (B),
as they could interfere with the reading of
the photocells.
After placing the materials and supports on the loading surface, return the selector to AUTO mode.
6.7.2
SWITCHING ON THE VACUUM PUMP
Turn on the vacuum pump and set the tap according to the material size (Figure 6-2)
0 (zero) Point nr.2
A
Figure 6-13
Figure 6-14
Summary of Contents for OMNIA
Page 1: ...OMNIA Instruction and Maintenance Manual...
Page 2: ......
Page 65: ......
Page 66: ...002695 rev 02...
