OMNIA
43
6.7.7
PREPARING THE CREASING TOOL
Insert one of the nine creasing wheels available (2) as shown in the diagram above until the magnet (3) at the base of
the tool holds to the creaser.
6.7.8
FITTING A CUTTING BLADE VERSATOOL (OPTIONAL)
Warning!
Handle the blade carefully, protect it, if necessary,
to avoid cutting. During reassembly use a rubber object to
keep it in its housing during tightening of the locking screw
.
•
Disassemble the head (see chapter
•
Remove the blade holder (1) from the cutting head by loosening the
set screw (2) with a 3 mm Allen wrench.
•
Loosen the blade holder screw (3) with a 2.5 mm Allen wrench and
insert the blade (4) until it reaches the pin (5), then tighten the
screw (9).
Figure 6-19
1
2
Figure 6-20
3
4
5
3
3
5
3
4
Figure 6-21
Summary of Contents for OMNIA
Page 1: ...OMNIA Instruction and Maintenance Manual...
Page 2: ......
Page 65: ......
Page 66: ...002695 rev 02...
