OMNIA
48
Figure 7-2
7
ADJUSTMENTS
To ensure a perfect result it may be necessary to perform some manual adjustments, such as:
7.1
ADJUSTING CUTTING AND CREASING DEPTH
To cut, it is essential that the cutting blade depth slightly exceeds the thickness of the material being cut. To obtain
this condition it is necessary to carry out the following operations: Loosen the knob (1), turn the head register (2)
anticlockwise (to increase), or clockwise (to decrease) the blade cutting depth. Then tighten knob (1).
To adjust the creasing pressure you should loosen the knob (3), turn the register (4) anticlockwise (to increase), or
clockwise (to decrease) the creasing pressure. Then tighten knob (3)
7.2
REGULATING THE VERSATOOL CUTTING DEPTH
To adjust the VersaTool cutting depth is sufficient turn the knob (1) anticlockwise
(to increase), or clockwise (to decrease) the cutting depth.
NOTE! One
unit on the counter corresponds to 0,1 mm (
0,004”
).
Ten units correspond to 1 mm (0,040
”)
Figure 7-1
+
-
+
-
3
4
2
1
-
+
1
Summary of Contents for OMNIA
Page 1: ...OMNIA Instruction and Maintenance Manual...
Page 2: ......
Page 65: ......
Page 66: ...002695 rev 02...
