background image

 

MP80.PUB  Version 1.07                                              6                        

 

Exclusions and Limitations: 

1. This Warranty does not cover tarnish, discoloration or wear on the plated surfaces   Painted finishes will change 
colour after initial firing and will continue to change through the lifetime of the stove. This is normal occurrence for 

all high temperature coatings. 

2. This Warranty does not cover gasket material or firebrick. 

3. Blaze King strongly recommends installation by a certified installer. Failure to comply may adversely affect 
coverage under the terms of this warranty. This Limited Warranty covers defects in materials and workmanship only 

if the product has been installed in accordance with local building and fire codes; in their absence refer to the 

owner’s manual. If the product is damaged or broken as a result of any alteration, wilful abuse, mishandling, 
accident, neglect, or misuse of the product, the Limited Warranty does not apply. 

4. The stove must be operated and maintained at all times in accordance with the instructions in the Owner’s 

Manual. If the unit shows signs of neglect or misuse, it is not covered under the terms of this Warranty policy. 
Performance problems due to operator error will not be covered by the Limited Warranty policy. 

5. Some minor expansion, contraction, or movement of certain parts and resulting noise, is normal and not a defect 

and, therefore, is not covered under this Limited Warranty. 

6. Misuse includes over-firing. Over-firing can be identified later by warped plates and paint pigment being burnt off. 
Over-firing this appliance can cause serious damage and will nullify the Limited Warranty. 

7. The Limited Warranty will cover glass thermal breakage only and will not cover misuse of the stove glass, 

including but not limited to: 
a) Glass that is struck, has surface contaminates or has had harsh or abrasive cleaners used on it. 

b) If the door is slammed or is closed while wood in the firebox is protruding out the stove opening thus striking the 

glass. 
8. This warranty does not cover products made or provided by other manufacturers and used in conjunction with the 

operation of this stove without prior authorization from Blaze King The use of such products may nullify the Limited 

Warranty on this stove. If unsure as to the extent of this Limited Warranty, contact your authorized Blaze King 

dealer before installation. 
9. Blaze King will not be responsible for inadequate performance caused by environmental

 

conditions. 

10. The Limited Warranty does not cover installation and operational related problems such as use of downdrafts or 

spillage caused by environmental conditions. Environmental conditions include but are not limited to nearby trees, 
buildings, roof tops, wind, hills, mountains, inadequate venting or ventilation, excessive offsets, negative air 

pressures or other influences caused by mechanical systems such as furnaces, fans, clothes dryers etc. 

11. The Limited Warranty does not cover damage caused by burning salt-saturated wood, corrosive driftwood, 
chemically treated wood or any fuel not recommended in the Owner’s Manual (use cord wood only). 

The Limited Warranty is void if: 

a) The stove has been operated in atmospheres contaminated by chlorine, fluorine or other damaging chemicals. 

b) The stove is subject to submersion in water or prolonged periods of dampness or condensation. 
c) Any damage to the unit, combustion chamber or other components due to water, or weather damage which is the 

result of, but not limited to, improper chimney/venting installation. 

d) Salt air in coastal areas or high humidity can be corrosive to the finish; these environmental conditions can cause 
rusting. Damage caused by salt air or high humidity is not covered by the Limited Warranty. 

12. Exclusions to the Limited Warranty include: injury, loss of use, damage, failure to function due to accident, 

negligence, misuse, improper installation, alteration or adjustment of the manufacturer’s settings of components, 
lack of proper and regular maintenance, alteration, or act of God. 

13. The Limited Warranty does not cover damage caused to the stove while in transit. If this occurs, do not operate 

the stove and contact your courier and/or dealer. 

14. The Limited Warranty does not extend to or include paint, door or glass gaskets or firebricks damage caused by 
normal wear and tear, such as paint discoloration or chipping, worn or torn gaskets, chipped or cracked firebrick, etc. 

15. The Limited Warranty does not include damage to the unit caused by abuse, improper installation, or 

modification of the unit. 
16. Damage to plated surfaces caused by fingerprints, scratches, melted items, or other external scores and residues 

left on the plated surfaces from the use of abrasive cleaners or polishes is not covered in this warranty. 

17. Blaze King is free of liability for any damages caused by the stove, as well as inconvenience expenses and 
materials. The Limited Warranty does not cover incidental or consequential damages. 

18. The Limited Warranty does not cover any loss or damage incurred by the use or removal of any component or 

apparatus to or from the Blaze King stove without the express written permission of Blaze King and bearing a Blaze 

King label of approval. 
19. Any statement or representation of Blaze King Products and their performance contained in Blaze King 

advertising, packaging literature, or printed material is not part of the Limited Warranty. 

20. The Limited Warranty is automatically voided if the stove’s serial number has been removed or altered in any 
way. If the stove is used for commercial purposes, it is excluded from the Limited Warranty. 

 

Summary of Contents for MP80



























Reviews: