11
Wiring
Access
Position the box top saved from unpacking the table on the floor, near the legs.
Now, rotate the legs so the two other bolt holes
from the photo line up with the corresponding
holes in the table. The legs should be at roughly
a 45-degree angle to the table, with the leg
leveler openings should be parallel to the
bottom of the table and flat to the floor. Install
the four leg levelers.
Use a #106 key to open the CPU ACCESS DOOR
(see photo) on the bottom surface of the table.
Take the Overhead Wire Harness from the Parts
Kit. Feed the end marked “TABLE SIDE / A” into
the leg closest to the CPU Access Door and into
the table using the Wiring Access Hole in the leg
and cabinet.
From the CPU Access Door, pull the Overhead
Wire Harness into the table cavity.
Plug two USB Connectors
into the Motherboard
Ports as shown to the left
(either connector can
plug into either USB port
on the motherboard)
Then connect the HDMI
video to the Motherboard
Port as shown to the right.
Last, plug the white 4-pin
and 6-pin connectors to
the available open
connections in the CPU
Access panel
