15
Installing the Overhead Display Unit
Use care during this step, dropping the
overhead onto the playfield will almost
certainly damage the playfield and render
the game unplayable. If the table is in the
normal, upright position, we recommend
having TWO people to support Overhead
Display Unit for installation while a third
person secures the overhead with nuts and
washers. DROPPING AN OVERHEAD ONTO
A PLAYFIELD IS NOT A COVERED
WARRANTY DEFECT.
We also suggest removing the overhead
bulbs during installation, or using a 12”
extension to reach the bolts, but still leaving
the protective cardboard on the fluorescent
bulbs.
One end of the overhead will have a
Directional Indicator marker. THAT END OF
THE OVERHEAD SHOULD BE ORIENTED
TOWARD THE COIN DOOR END OF YOUR
BLACK HOLE TABLE.
Feed the Overhead AC Harness and Overhead Wire
Harness through the rectangular cut out. Then, secure
the four nuts and washers attaching the overhead with
the ½” socket (and the 12” extension).
Connect the Overhead Wire Harness HDMI cable to
the Splitter Input Connection, and the 6, 4 and 3 pin
connectors to their corresponding plugs in the
overhead.
At this point you may remove
the protective cardboard
from the Fluorescent Lamps,
or reinstall the lamps if you
removed them for safety
while attaching the Overhead
Display Unit.
