20 |
P a g e
Ball Return Inspection:
CAUTION:
Please remove power by turning the ON/OFF switch at the rear to the OFF position
and unplug the power cord before lifting the Table Lid unless you absolutely must have power
on for viewing balls in
“Free Play” or “Auto Cycle”.
Properly insert the Prop Stick (*CE tables
only) when lifting the table Lid.
Inspect the underside of the Triangle Cup Assembly to make sure no balls are trapped and that no debris is
stopping the balls from rolling down into the metal
Inlet Trough
chute. Inspect the chute for any debris as well.
Search for any debris that may be lodged in the Ball Return piping. If debris is found you can try to place the
game into
“Free Play”
mode and press buttons until the debris works itself down to the wire frame Solenoid
Trough. If this does not work you may have to disconnect the piping or blow it clean using a vacuum cleaner
blower.
LED Inspection & Remote Controller Battery Replacement:
CAUTION:
This procedure requires the power to be on during inspection.
Inspect all LED lights to make sure they are all working. The LED lighting in the T-Molding is controlled by the
remote controller in the Accessory Bag. You can press various buttons to select the color or speed of these LEDs.
Note that there is a battery in the remote controller (CR2025 Lithium Battery 3V) that may need replacing every
few years. If you find an LED strip that is not working refer to
Section 9
– Troubleshooting
for details.
The LED lights under the Triangle Cup Assembly can be turned on using the
Troubleshooting
screen on the
HMI Touch Screen. Refer to
Section 9
– Troubleshooting
for details.
The LED lights on the Table Lid under the black plastic can be inspected for any LED lights that are not working.
If you find an LED that is not working refer to
Section 9
– Troubleshooting
for details.
Inspect the LED lights in the Beverage Holders and around the Ball Exhaust Chute to make sure they are all on. If
you find an LED that is not working refer to
Section 9
– Troubleshooting
for details.
Inspect the LED Lights inside the speakers to make sure they both work. If you find a set that is not working refer
to
Section 9
– Troubleshooting
for details.
Summary of Contents for Jet-Pong Coin JP100
