ICON5 / ICONX
Flow Meter Setup
• If a flow meter will be used in this application,
continue with step 1.
• If a flow meter will not be used in this application,
continue with step 6.
To set the Flow Meter, follow these steps:
1. Push
Menu
,
System
,
Data
, and
Flow/Hours
to
display the Flow/Hours screen. See Figure 32-1.
2. Select the
Flow Multiplier
field. See Figure 32-1.
3. Using the numeric keypad, enter the manufactur-
er’s recommended pulse multiplier value in either
gallons per pulse or liters per pulse, depending
on the unit of measure.
4. To enable the Low Flow Limit, select the
Low
Flow Limit
field to open the numeric keypad.
5. Enter the minimum flow rate value into the nu-
meric keypad and push
Enter
to retain the value.
The range is 1-999 gpm (lpm).
NOTE
• The Low Flow Limit will automatically be
enabled when a valid number is entered
into the keypad, this will be indicated
when the Low Flow Limit checkbox be-
comes checked. A value of 0 disables the
Low Flow Limit.
5
6
1
2
3
4
Figure 32-1 1. Menu
2. System
3. Data
4. Flow/Hours
5. Flow Multiplier
6. Low Flow Limit Field
32
Setup
Summary of Contents for VRI-iS
