Calibration Procedure
Maintenance Procedures
Force 2 Service Manual
6
-
5
4.
Adjust the Pure Cut Output Calibration
a.
Attach a 300 ohm load to the generator output.
b.
Set cut power setting display at 300 W and adjust R74 for 300 W
output.
c.
Attach a 100 ohm load to the generator output.
d.
Verify that cut output is 290 W - 325 W. If not, adjust R70 for the
correct output. R70 is the cut ICON adjustment.
5.
Blend Modes Output Calibration
a.
Attach a 300 ohm load to the generator output.
b.
Set the blend 2 power setting display at 200 W and adjust R75 for
200 W output. R75 is the blend ECON adjustment.
c.
Attach a 100 ohm load to the generator output.
d.
Set the blend 1 power setting display at 250 W.
e.
Verify that blend 1 output is 210 W - 260 W. If not, adjust R71 for
correct output. R71 is the blend ICON adjustment.
6.
Coag Output Calibration
a.
Adjust R61, R62, R63, and R101 fully clockwise.
b.
Attach a 300 ohm load to the generator output.
c.
Set coag power setting display to 30 W, activate and adjust R76
(ECON) for approximately 37 W (350 mA).
d.
Press the
READY
and
COAG POWER DOWN
buttons at the same time to
enter the low voltage coag mode, set low voltage coag power
setting display to 30 W and adjust R101 for approximately 32 W
(330 mA).
e.
Verify the output power for coag at 30 W is 32 W (330 mA) and low
voltage coag at 30 W is approximately 32 W (330 mA). Adjust R76
and R101 as needed.
f.
Set coag power setting display to 120 W and verify output power
for approximately 112 W (610 mA). Ensure that R72 (COAG ICON)
is adjusted fully clockwise.
7.
Bipolar Output Calibration
a.
Attach a 100 ohm load to the generator output.
b.
Set R73 to mid setting. Turn R69 fully clockwise.
c.
Set the bipolar power setting display at 70 W and adjust R73 for
70 W (836 mA) output.
d.
Turn R69 counterclockwise until it affects bipolar output in part 7b.
Then, turn R69 clockwise one turn.
Summary of Contents for Force 2-2 PCH
