13
© Vallox Oy - All rights reserved
INS
TALLA
TION
INSTALLATION SITE
Vallox 101 MC must be installed in a location where the
temperature remains above +10 °C. When the unit is
installed without a protective enclosure, the location
must be chosen so that its noise does not cause any
disturbance. Such locations include storage premises and
technical spaces.
NOTE!
Remember to make a service door in the finished ceiling
so that the connection cables can be accessed. The
service door should be located roughly 500 mm from the
unit door.
162
12
21
20 60
2030 30
20
60
11
20
30
30
11
84
84
35 30
35
ø7 14 kpl
550
30
25
25
30°
Wall mounting plate
283
164
6
604
Bottom edge of
the wall mounting plate
The top surface of the side panel of the unit can
be installed against the finished ceiling surface.
When the wall mounting plate is used, it must be
observed that the ventilation unit will rise roughly
10 mm above the final installation height!
The outer diameter
of the duct is 12 mm
Wall mounting
Mount the Vallox 101 MC on the wall with a mounting plate,
as shown in the adjacent figure. Make sure that the unit is
horizontally level after mounting.
Wall structure
The wall structure must be observed in the mounting.
Avoid mounting the unit on hollow, echoing intermediate
walls and on bedroom walls, or take measures to prevent
conduction of noise.
