Page 38
6: Replace secondary transfer bias component
Turn off the power. When the printer is in power save mode, please press <save power> to exit this mode and then turn off
the power.
Please replace according to the following steps. Please refer to the "reset counter" (page 45) to reset the counter.
Note: If it indicates that the component has reached the end of its service life but can still be used, then you can reset
the counter directly.
8-5-5
Take a new IBT belt cleaning component and inset it into
the printer.
8-5-6
Press the knob to tighten it and fasten the IBT belt cleaning
component in place.
8-5-7
Turn the cover of the IBT belt cleaning component to the
left to close the cover.
8-5-8
Close the front cover.
8-6-1
Open the side door and open the left upper cover while
lifting the unlocking handle A.
8-6-2
Push the handle to the direction of the arrow.
