Figure 2
2 ) Remove the clamp from the box and band the clamp onto the arm using
3/4" to 1-1/4" heavy duty stainless steel bands (not included) and apply the
following:
(See Figure 2)
b)
The Valmont
®
“V”on the clamp should be right side up.
c)
Using a level on the flat surface where the Valmont “V” is embossed
(b), check that the TR1 Clamp is plumb vertically (0 +/- 1 degree) from
the axis of the arm before tightening the bands.
Band the clamp as close to the free end of the mast arm, not to exceed
5 feet, to ensure the best vibration dampening performance. If there
is a traffic signal or sign located toward the end of the mast arm, you
might want to consider hiding the damper behind it.
a)
4
Summary of Contents for Mitigator TR1
Page 2: ......
