7
6 ) check that the TR1 Damper is within 1 degree of plumb in all directions.
After installation is complete, check the casing for objects magnetically
attached to the TR1 Damper. If any, remove these objects which will
render the TR1 Damper ineffective.
5 ) Rotate the TR1 Clamp to be plumb vertically (0 +/- 1 degree), and tighten
the two hex head bolts to snug, then an additional 3/8 turn.
(See Figure 5)
(Note: Using the indexing to assist in finding level, and to hold position
when tightening.)
Figure 5
Summary of Contents for Mitigator TR1
Page 2: ......
