15. OUTLET BAFFLE AND FASCIA FITTING
Homeflame Dream model.
15.1
Fitting the outlet baffle.
Locate the outlet baffle and secure in place
using two tapping screws supplied (See figure
29).
15.2
Fitting the fascia.
1.
Supplied with the fire is a self adhesive
control position label. Peel the backing from
the label and place as in figure 30.
2.
Place the fascia against the fireplace front
surface so that the two retaining plates at the
back of the fascia are above the two upper
retaining brackets at the top of the convection
box. Lower the fascia making sure that the
rear retaining plates locate fully into the
retaining brackets on the convection box (See
figure 30). If the inlet pipe runs along the front
of the fireplace, the bottom of
the fascia will have to be
swung forwards to clear the
pipe while lowering the casting.
3.
Secure the bottom of the
fascia using the two machine
screws and washers supplied
(See figure 31).
15.3
Fitting the firefront
casting.
1.
The firefront casting is
supplied with a black baffle
fitted to its rear. This has to be
removed and replaced with the
firefront casting baffle supplied
with the fire. To do this remove
the two screws on the rear of
the casting (See figure 32) and
remove the existing baffle.
Secure the new baffle in place
using the two screws.
2.
Place the firefront casting
©
Baxi Heating U.K. Limited 2008.
Page 32
Figure 30. Fascia location (Fascia may differ from
that shown).
Figure 29. Outlet baffle.
INSTALLER GUIDE
Summary of Contents for 761
Page 56: ...Baxi Heating U K Limited 2008...
