upper retaining brackets. See section 15 of this guide for detailed fitting instructions.
Homeflame Harmony model.
1.
Carefully lift the fascia upward and forward.
2.
Place the fascia in a safe place away from the gas fire.
3.
To fit the fascia, place the top of the fascia against the fireplace front surface so
that the two retaining plates at the back of the fascia are directly above the two
retaining brackets on the convector box. Keeping the lower part of the fascia clear of
the ceramic fuel effect, lower the fascia making sure that the rear retaining plates
locate fully into the retaining brackets on the convection box (See figure 33). The
fascia bottom is held in place with magnets. These should be located as in figure 33.
17.5 To replace the control slide unit.
1.
Remove the fascia (See section 17.4).
2.
Remove the knurled screw securing the control
linking arm to the burner (See figure 38).
3.
Detach the slide unit by removing two screws
securing it to the convection box flange (See figure
39).
4.
Replace in the reverse order.
17.6 To replace the control slide button.
1.
Remove the fascia (See section 17.4).
2.
Unscrew and remove the two screws securing the
slide button to the slider mechanism.
3.
Remove the button, replace and fit in the reverse
order.
©
Baxi Heating U.K. Limited 2008.
Page 37
Figure 39. Slider mechanism
removal
Figure 38. Control linkage
disconnection
INSTALLER GUIDE
Summary of Contents for 761
Page 56: ...Baxi Heating U K Limited 2008...
