16.1 To remove the fascia.
(Aspect Glass, Tranquility and Fascination models).
1.
The fascia is held in place by four retaining plates at
the back of the fascia. These slot into four retaining
brackets on the hotbox. To remove the fascia, hold the
sides of the fascia and lift upward and forward. The
fascia should lift clear of the hotbox (See figure 37).
2.
Replace in the reverse order.
(Landscape, Visia and Serenity models).
1. Visia model only.
There is a heat baffle that is
screwed to the fascia and spillage plate (See figure 38).
Unscrew and remove this heat baffle.
2.
Remove the two
screws from the base
of the fascia (See
lower image in figure
39).
3.
Support the fascia
and lift the fascia
clear of the hotbox.
Page 36
©
Baxi Heating U.K. Limited 2008.
INSTALLER GUIDE
Figure 39. Fascia removal
Figure 38. Fascia heat baffle location
Figure 37. Fascia removal
(The fascia may differ from
that shown)
