minutes of operation. To do this, simply set the control knob to its ‘HIGH’
setting. This will also burn off any carbon deposits that may have formed
during previous operations.
iv)
If operating the appliance for long periods it is beneficial occasionally to
change the settings. This will also help to remove any carbon deposits that
may form during operation.
Glass bowing.
It is normal for the glass panel on the fascia to bow slightly when hot.
Lighting with a taper
(For models that do not have glass panels).
(See figure 6).
In the unlikely event of failure of the ignition
spark, the pilot can be lit by a taper or long
spill. Insert the taper or spill into the gap in the
fuel effect at the left hand side. Depress the
control knob, turn it to PILOT/IGN.
To turn off.
To turn the main burner off but leave the
pilot alight, partially depress the knob and turn
to PILOT/IGN.
To turn the fire fully off, partially depress
the knob and turn to OFF.
Wait at least three minutes before
relighting.
While cooling, the fuel effect may
make some crackling noises. This is quite normal.
CLEANING YOUR FIRE
To maintain the high performance and quality finish of your fire please follow these
guidelines:
Before attempting to clean the fire, please remember to turn off the fire and wait
for the appliance to cool completely. The fire will retain heat for some time before
cleaning can begin.
If any pieces of debris are found in the hotbox, have the chimney inspected before
further use.
Metal Parts.
Clean the metal parts with a slightly damp, lint free non-abrasive cloth and then
dry.
Do
not
use abrasive cleaners, as these will scratch the fire surface.
Fascia -
Clean the metal parts with a slightly damp cloth and then dry. If this does
Page 49
©
Baxi Heating U.K. Limited 2008.
OWNER GUIDE
Figure 6. Lighting with a taper (Fuel
effect may differ from that shown)
