6.
Remove the two screws to the side of the
burner cover (See figure 11)
7.
Detach the burner cover by lifting clear
of the burner module (See figure 11)
8.
Remove the protective film from the
burner cover. Place the burner cover in a
safe place away from the work area.
9.
Detach the burner unit from the hotbox
by lifting clear.
10.
Fit the two “U” section seals to the
bottom edges of the hotbox side flanges.
See figure 12.
11.
It is important that the grommet
supplied in the loose parts pack is fitted
to the hole in the rear of the convection
box.
12.
For concealed connection only:
Pierce the grommet to allow the pipe
to pass through it. The grommet
should envelop the pipe. If the hole is
larger than the pipe, seal it with tape.
Do not pierce the grommet unless
the supply pipe is to pass through it
.
Page 20
INSTALLER GUIDE
Fireback 12. Fitting “U” Seals
Figure 11. Removal of Burner Module
