Valor 1200EAN, Installation & Operating Instructions Manual

38

Temperature

Use this setting when you come in and want to enjoy a set temperature. 

1.  Select either the 

☼

temp

 M

ODE

 or the 

☽

temp

 MODE

 by briefly pressing the 

SET

 button.

2.  Hold the 

SET

 button until the 

TEMP

 display flashes.

3. 

Set the desired temperature with the 

or the 

buttons. 

Note: 4.5°C/40°F is the minimum temperature setting.

4.  Press the 

OFF

 button or simply wait and the display will go to the temperature control mode. 

Note: If you would like the Nighttime Setback temperature control to turn off, decrease the 

☽

temp

 MODE 

setting until [---] appears on the display.

Your fireplace will reach the set temperatures and the remote handset will check the 

temperature every five minutes, adjusting the amount of fuel needed to give you a steady, 

even heat.

5. 

The display must remain in 

TEMP

 mode on the remote handset.

Low Battery Indication

Remote handset:

BATT

 will appear on the display when the battery needs to be replaced.

Replace with one 9 V battery (alkaline recommended).

Receiver:

 Three short ‘beeps’ will sound when the motor turns when the batteries need to be replaced. Replace with four 

1.5 V batteries (alkaline recommended).

NOTE: 

With very low battery, the valve shuts off the fire completely. This does not happen when the power supply is 

interrupted.

Automatic Standby Mode (when in Temp or Timer modes only)

If there is no transmission from the handset to the receiver within a 6-hour period, the appliance will go to 

STANDBY

(pilot) mode.

Handset / Receiver Match

The remote control handset and receiver are programmed to function together. In case of a replacement of the handset or 

the receiver, you will need to reset the receiver to allow them to function together. Contact your dealer for details

Timer

It is possible to program two periods of time per day at which your fireplace will turn on and off 

automatically. 

For example, you can set your fireplace to turn on in the morning just before you get up (P1 

☼ 

[

start time

]) 

and to turn off when you leave for the day 

(

P1

☽ 

[stop time]). Then, you can set your 

fireplace to turn on again at the end of the day (P2 

☼

 [

start time

]) 

and to turn off when you go to 

bed at night (P2 

☽

 [stop time]).

If you wish to set only one time period at which your fireplace will turn on and off, program P2 

☼

[

start time

] 

and P2 

☽

 [stop time] for the same time as P1 

☽

 [stop time].

1.  Select 

TIMER 

mode by briefly pressing the 

SET

 button.

2.  Press and hold the 

SET

 button until 

TIMER

 is displayed on the lower right hand side.

3.  Press and hold the 

SET

 button until P1

☼

 and the time display flashes. Set the start time by 

pressing the 

button for the hour and the 

button for the minutes. Then, briefly press 

SET

 to 

P1 

☽ 

and set the stop time in the same manner you just set P1 

☼.

4. 

Briefly press the 

SET

 button again for the next burner cycle time, which will be P2 

☼

 and 

P2 

☽.

5. 

Once all four times are set, press 

OFF

 or simply wait to complete programming.

6.  The remote handset must remain in 

TIMER

 mode to function automatically.

Remote Control Operation