46
The receiver and battery box are located inside
the front panel of the appliance.
Battery box
Receiver
CAUTION
DO NOT USE
a screwdriver or other metallic
object to remove the batteries from the battery box!
This could cause a short circuit to the receiver.
Ignition Wire Connection
(spade type connector)
Be careful when removing
and reinstalling: not to
bend or break the spade
connector
Ignition Wire
Antenna
Valve Wire Harness
Wall Switch Harness
IMPORTANT: The connection
can only be done one way.
Do not force it or damage the
pins on the receiver box!
CAUTION
Do not run the switch wire over the top of the
fi
rebox.
Route the wire so it does not contact the
fi
rebox.
Install Wall Switch Kit (required)
The wall switch kit is provided with this appliance. It is
connected to the receiver in the
fi
replace. The receiver
is located on the left side of the appliance, left of the
control valve behind the appliance’s front panel. The
battery box is located on the right hand side of the
appliance under the
fi
rebox.
1. Decide where the switch is to be installed on the
wall. Install an electrical outlet box or mud ring as
required (not supplied) to house the switch controls.
Fasten the wiring to framing using insulated staples
(not supplied).
2. Thread the switch wire through an access hole in
the appliance.
3. Pull out the receiver and the battery boxes.
Remove
the batteries from the receiver or battery box if
they contain any.
You can remove the ignition wire
to improve access to the receiver.
4. Take the switch wire and plug it into the receiver’s
connection slot as indicated (the other slot should
already be
fi
tted with the valve’s wire harness
connector). See diagrams below.
IMPORTANT: The connection can only be done
one way. Do not force it or damage the pins!
5. On the outside of the
fi
replace, run the switch wire
into the outlet box. Use insulated type staples to
secure the wiring to framing.
6. Plug the wire into the switch plate and to the outlet box.
7. Reconnect the ignition wire to the receiver if it was
previously removed.
IMPORTANT: Make sure the ignition wire DOES
NOT TOUCH the receiver’s antenna.
CAUTION
DO NOT PUT BATTERIES IN THE REMOTE
CONTROL RECEIVER OR THE BATTERY BOX
until the wires are connected to the burner
control unit as short-circuit could result in the
destruction of the electrical components.
Installation
QUALIFIED
INSTALLER
Summary of Contents for 1500INO (NG)
Page 56: ......
