10
www.valortrailers.com PHONE: 208-810-4900
Rev 05/20/2022
Removal of Release Tool Assembly
Step
No.
Action
2.
Apply approximately 70 pounds per square inch (PSI) of air pressure to the brake system; this
should be sufficient to remove the spring pressure and loosen the release tool assemblies.
NOTE:
The release tools can be removed without applying air pressure to the brake system,
although the removal process is easier if air is applied.
3.
Slowly loosen the nut on the release tool until the spring pressure has been released.
4.
Rotate the release tool approximately
one-quarter
turn to align the tee with the slots and pull out.
5.
Install the release tool assembly in the storage position on the bottom of the can for future use.
6.
Cover the release tool assembly port with the attached rubber seal.
7.
Repeat this procedure for all spring brake cans.
Note:
See Figure 1, Spring Brake Release Tool Assembly.
Figure 1: Spring Brake Release Tool Assembly
Summary of Contents for 54TS
