2
Re-use gaskets
if in good
condition.
If not, clean
and use
supplied gaskets.
Installation on 530 and 534 heaters
(Note: Instructions are general as 556CLA may be
installed on Top or Back of Heater.)
1. Remove blank plate and gasket to gain access to
exhaust spigot. Retain plate and good gaskets for
re-use later.
2. Remove existing outer intake plate. Retain good
gasket only for re-use.
3. Remove existing exhaust spigot—gasket below
should remain on heater.
4. Install new co-linear exhaust spigot re-using existing
screws. Ensure all screws are reinstalled tightly.
5. Install new co-linear outer plate (note up/down
front/back orientation on drawing) re-using existing
good gaskets and screws. Use 6 additional screws
supplied to seal outer plate to gasketed
fl
ange of
exhaust spigot.
6. Re-
fi
t the blank plate.
7. Connect 3” dia.
fl
ex liners directly to their respective
outer plate collars using hose clamps (included) and
2 sheet metal screws per liner to prevent the liners
to sllip from the collars.
8. Attach the conversion plate
“This
fi
replace has been
converted...”
label
to the existing
fi
replace
using
screws or other mechanical means and store any
removed parts in back of the existing
fi
replace for
future use.
3
2
1
2
1
3
4
5
6
#
Description
Part Number
1
Co-linear outer plate
4000289
2
Intake gaskets (2)
4000941
3
Round gasket
4000418
4
Exhaust spigot
4000288
5
Spigot gasket
4000938
5
2.5-4.5” hose clamp (2)
9800064
Conversion plate
4000853
Kit Contents
Gaskets
This is the
bottom edge
when installing as rear outlet
This is the
front edge
when installing as top outlet
Exhaust
collar
6
5
4
7
