Set (scrolls
through
modes and
settings)
OFF (returns
to set mode,
turns the burner
and the pilot off)
Large flame
button (flames
up, sets hours,
temperature)
Small flame
button (flames
down and off,
sets minutes,
temperature)
Current
temperature
(F or C)
Current time
(12 or 24 hour clock)
Modes (Manual,
Temperature, Timer)
Handset
sensor
Battery status
Current
programmed
period (Timer)
Period
start or end
(Temp, Timer)
Fan setting (if used)
Burner setting
Owner’s Information
Manual On/Off Switch
In cases where you want to turn off your fireplace and
cannot do it with the remote control handset (misplaced,
lost, dead batteries, etc.) or if you need to replace the
batteries in the battery box, you can turn off the appliance
with the manual switch located on the left hand side of the
appliance. Remove the left hand side door to access the
switch.
If the 1265WSK Wall switch is installed and the remote
control will not be used, remove the battery from the
handset and store it away.
If you are planning not to use your fireplace for a prolonged
period of time, remove the battery from the remote handset
and turn off the gas valve using
the manual ON/OFF switch.
Pilot/Automatic Shut-off
The remote control system is equipped with safety features allowing it to shut the fire down to pilot or to shut-off the pilot
completely in certain situations. See
Remote Control Operation
section in the following pages for more information.
Remote Control Operation
Your fireplace remote control helps you get the comfort, convenience and aesthetics you want from your gas fireplace.
The remote controls your fireplace in different ways.
IMPORTANT:
BEFORE YOU BEGIN, please note that on this system, the settings of time, temperature and automatic
ON/OFF
can only be programmed when the function display is flashing
. Be patient when programming as it can take
a few seconds to set.
NOTE: Before using the remote control system for the first time,
the receiver and the handset must be
synchronized. See the section
Initial Remote Control Set-up
on page 19 in this manual.
OFF
ON
Display Overview
Handset Overview
Note: In the TEMP or TIMER modes, the remote
handset senses the room temperature and adjusts the
flame accordingly.
To communicate, the handset should be within 15 feet
(4.5 meters) of the fireplace.
Do not leave the handset on the mantel or hearth.
24
