To turn the fire off.
1.
Slide the control button up again to the off (O) position. Both pilot and all radiants
should go out. While cooling the radiants may make some crackling noises. This is
quite normal.
Wait at least three minutes before attempting to relight.
Lighting with a match or taper.
(See figure 3).
In the unlikely event of failure of the ignition
spark, the pilot can be lit by a taper or long spill.
Slide the control knob to the ignition / low
position (
L). While keeping the knob
depressed, light the pilot by inserting a long
match or taper into the opening shown in figure
3 (The upper slot of the two).
When the pilot is alight, keep the knob
depressed for about ten seconds to allow the
flame sensing probe to warm up before setting
to your preferred heat level.
For your own convenience, have the heater
serviced as soon as possible.
CLEANING YOUR FIRE
Turn the fire off and allow it to cool before attempting any cleaning.
Normally the fire will only need dusting. The bright metal trims may be cleaned with a
damp cloth and dried with a soft duster. Obstinate marks can be removed from the
guard and trims using soapy water.
Never use abrasive cleaners.
The radiants can be cleaned with a soft brush - see the following for how to remove
the radiants.
Page 38
©
GDC Group Ltd. 2011
OWNER GUIDE
Figure 3.
Summary of Contents for BRAVA 348
