2
Remote Control Operation
Your fi replace remote control helps you get the comfort, convenience and
aesthetics you want from your gas fi replace. The remote controls your fi replace
in diff erent ways.
IMPORTANT:
BEFORE YOU BEGIN, please note that on this system, the
settings of time, temperature and automatic ON/OFF can only be programmed
when the function display is fl ashing. Be patient when programming as it can
take a few seconds to set.
Setting the time
The fi rst thing to do is to set the time.
1. With your thumb, hold down
both
the
AUTO
and
TIMER
buttons until
F
fl ashes.
Let go.
2. Note the digital clock on the bottom right hand corner. The ▲ button sets the
hour; the ▼
button sets the minutes. Set the time.
Note: You must start setting the time while the
F
is fl ashing. If it stops fl ashing,
go back to 1.
3. The display shows °C/24-hour or °F/12-hour. To change the temperature/hour
display, press on the
AUTO
button while the display fl ashes.
4. Let go and wait until the fl ashing stops. The remote shows the time you set. It
also shows the current temperature.
Setting the temperature
Use this setting when you come in and want to enjoy a specifi c temperature.
1. Push the
AUTO
button until a number and
F
fl ash. Let go.
2. While it is still fl ashing, push the ▲ and ▼ buttons to the temperature you want.
Let go.
Your fi replace will reach that temperature and the remote will check the temperature
every fi ve minutes, adjusting the amount of fuel needed to give you a steady, even heat.
Setting the fl ame
Use this setting when you want a particular fl ame level. For instance, you want to
watch fl ames burn at their highest level and you don’t mind if the room is too hot.
1. To raise the fl ame, press and hold the ▲ button until the flame gets to the
desired level. Let go.
2. To lower the fl ame, press and hold the ▼ button until the fl ame gets to the
desired level. Let go.
The
fl ame level
will remain just as you set it.
