Valor H3 Series, Homeowner'S Manual

22

 Appendix A - Remote Control Operation

Radio Frequency

315 MHz for USA and Canada.
This device complies with Part 15 of the FCC Rules and 

with Industry Canada license-exempt RSS standard(s). 

Operation is subject to the following two conditions:

(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, 

including interference that may cause undesired 

operation.

NOTE: Before using the remote control system for 

the 

ȴ

 rst time, 

the receiver and the handset must 

be synchronized. See the section

 Synchronize Remote 

Control

. 

IMPORTANT:

BEFORE YOU BEGIN, please note that on this 

system, the settings of time, temperature and automatic 

ON/OFF 

can only be programmed when the function 

display is 

ȵ

 ashing

. Be patient when programming as it 

can take a few seconds to set.

Note: In the TEMP or TIMER modes, the remote handset 

senses the room temperature and adjusts the 

ȵ

 ame 

accordingly. 
To communicate, the handset should be within 15

b

feet 

(4.5 meters) of the 

ȴ

 replace. 

Do not leave the handset on the mantel or hearth.

SET (scrolls through

modes and settings)

OFF (returns to set mode,

turns the burner and

WKHSLORWR΍

/DUJHȵDPHEXWWRQȵDPHV

up, sets hours, temperature)

6PDOOȵDPHEXWWRQȵDPHV
GRZQDQGR΍VHWVPLQXWHV

temperature)

Current 

temperature

(F or C)

Current time 

(12 or 24 hour clock)

Modes (Manual, 

Temperature, Timer)

Handset 

sensor

Battery status

Current

 programmed

 period (Timer)

Period 

start or end 

(Temp, Timer)

Fan setting (if used)

Turn Fireplace ON

Press    +   buttons until you hear a 

short beep; release buttons.
Beeps continue until pilot is lit.
Burner lits to maximum 

ȵ

 ame height 

and handset goes automatically to 

manual (MAN) mode.
NOTES: 

On the valve, MAN button must be at ON, in full 

counter-clockwise position 

.

ON/OFF switch (if equipped) must be in I (ON) position.

Turn Fireplace OFF

Press   button.
When pilot is just turned o

΍

 , wait 2 

minutes to light it again.

Standby Mode (Pilot Flame)

Press and hold   to set 

ȴ

 replace 

to pilot.

Adjust Flames Height

With pilot lit, press and hold buttons:

 = increase 

ȵ

 ame height

  = decrease 

ȵ

 ame height or

        set to pilot
For 

ȴ

 ne adjustment, tap buttons.

Express Low and High Fire

Double-click buttons:

 = increase 

ȵ

 ame to maximum 

        height “HI”

  = decrease 

ȵ

 ame minimum 

        height “LO”
NOTE: Flame goes to high 

ȴ

 re 

ȴ

 rst 

before going to designated low 

ȴ

 re.

x 2

x 2

in the 

fi

 replace Installation Manual.