9
ON:
parallel
to pipe
OFF:
perpendicular
to pipe
Operating your fireplace
Fireplace control devices
There are two ways to control your
fi
replace.
1. Thermostatic Remote Control turns
fi
re ON, OFF,
controls
fl
ame height and can be programmed to
function automatically—see
Appendix A - Remote
Control Operation
on pages 22–25.
2. Wall Switch turns
fi
re ON, OFF and controls
fl
ame height—see
Appendix B - Wall Switch Opera-
tion
on page 26.
Turn your
fi
replace ON
Press and hold:
- + buttons on remote, or
- ON-OFF button on wall switch
until a short beep con
fi
rms the start sequence has
begun; release buttons.
Continuing beeps con
fi
rm the ignition is in process.
The pilot lights up, then the
fi
replace.
If you need to light up the pilot manually, see the
Lighting Instructions card attached to the
fi
replace
—see page 7 to know how to access it. Also, a
copy of this card is reproduced in Appendix A of the
fi
replace Installation Manual.
Turn your
fi
replace OFF (including pilot)
Press and hold:
- button on remote, or
- ON-OFF button on wall switch
If the
fl
ames are on, they go down and you hear the
valve motor wind down. You hear a clunk and a beep
indicating that the valve has received the signal from
the remote control.
In the unlikely event that you cannot turn o
ff
your
fi
replace with the remote control handset, use the
wall switch; if the wall switch malfunctions and
will not turn o
ff
the
fi
replace, wait 8 hours and the
fi
replace will automatically go to pilot. You can then
access the controls inside your
fi
replace.
Alternately, turn o
ff
your house gas supply. In all
cases, call your dealer for service assistance.
Remote Control
Wall Switch
To use additional functions of your Remote
Control such as temperature or program
settings, visit
valor
fi
replaces.com/remotes
WARNING
Risk of severe burns! Surface of the
fi
replace are very hot during operation!
Ensure
fi
repace has cooled o
ff
before
accessing control.
WARNING
STOP IF YOU SMELL GAS! DO NOT LIGHT!
See cover page immediately!
