37
37
Owner’s Information
Setting the
fl
ame
Use this setting when you want a particular
fl
ame level. For instance, you want to
watch
fl
ames burn at their highest level and you don’t mind if the room is too hot.
To raise the
fl
ame, press and hold the
▲
button until the flame gets to the desired
level. Let go.
To lower the
fl
ame, press and hold the
▼
button until the
fl
ame gets to the
desired level. Let go.
The
fl
ame level
will remain just as you set it.
Programming time and temperature
You can set your
fi
replace to come on before you wake up and turn off after you
leave and then, turn on again just before you come home and turn off after going to
bed.
You can leave it like this for the heating season.
Decide what temperature you want your
fi
replace to be at. Also, decide what time
you want your
fi
replace to turn on and off. Finally, decide what time you want it to
come back on and off in the afternoon or evening. For the
fi
rst few times you set
the timer, it’s handy to write these times down.
Set the temperature (just as you did in the section
Setting the temperature.)
Press the
TIMER
button and hold it until
P1
☼
appears and flashes. Let go.
While
fl
ashing, push the buttons
▲
(hour) and
▼
(minutes) to set the time at
which you want your
fi
replace to turn on in the morning.
Press the
TIMER
button and hold it until
P1
☽
appears and
fl
ashes. Let go. While
fl
ashing, push the buttons
▲
(hour) and
▼
(minutes) to set the time at which you
want your
fi
replace to turn off when you leave.
Press the
TIMER
button and hold it until
P2
☼
appears and
fl
ashes. Let go.
While
fl
ashing, push the buttons
▲
(hour) and
▼
(minutes) to set the time at
which you want your
fi
replace will turn back on in the afternoon.
Press the
TIMER
button and hold it until
P2
☽
appears and
fl
ashes. Let go. While
fl
ashing, push the buttons
▲
(hour) and
▼
(minutes) to set the time at which you
want your
fi
replace to turn off in the evening.
That is all you have to do. Your
fi
replace will give you steady, even heat at the
temperatures and times you set.
Note: If you want to set your
fi
replace for only one time on and off, set
P2
☼
and
P2
☽
for the same times as
P1
☽
. The remote will record the
P1
☽
off time for both
P2
times.
To temporarily override the timer setting, just press
AUTO
or
▲
and
▼
to go back to
manual settings. Press
TIMER
to go back to your settings.
When your remote control displays
BATT
, you need to replace the battery with a
new 9 volt alkaline battery—6LR61/MN1604.
1.
2.
1.
2.
3.
4.
5.
6.
7.
