Conversion Procedure
1. If the
fi
replace is already installed, remove the front,
window, ceramic logs and brick liners.
2. Disconnect the gas inlet pipe from the inlet elbow
fi
tting on the valve.
3. Detach the rear log support by removing 5 screws
as shown.
4. Detach the burner module by removing 10 screws. If
the unit has been burned previously, it may be
necessary to pry the burner module gasket as they
tend to adhere when removed the
fi
rst time.
NOTE:
When converting log set appliance, 2 screws
are under the front log brackets (highlighted below).
5. Disconnect the burner elbow injector from the pipe,
using a 11/16” (17 mm) wrench.
6. Remove the 4 screws securing the burner brackets
to the burner tray.
7. Detach the two burner support brackets from the
burner by removing two nuts, using a 5/16” (8 mm)
wrench.
8. Accessing the pilot assembly from the underside of
the module, disconnect the pilot pipe, using a 7/16”
(11 mm) wrench.
9. Remove the pilot injector. Replace with the propane
gas injector.
Note - The pilot
injector should be
slipped onto the
end of the pipe
from the side. The
pilot pipe, with
injector attached,
should be inserted
into the assembly.
2