Installation
The 1730CIK kit is intended to be installed at the time of
framing, and before installing the wall
fi
nish.
With the 1700 engine installed and in place, you can
proceed with the following steps to install the 1730CIK
kit.
1. Break
o
ff
tabs from each corner of the
fi
replace’s
front opening (8 tabs, 2 at each corner). Bend tabs
back and forth to break them, or cut them with tin
snips. (These tabs are only for use with kits other
than the 1730CIK)
2. File or trim any remaining sharp edges. Be careful
not to allow material to fall into the appliance.
3. Slide CIK assembly into the opening as shown,
pushing it as far in as it will travel.
4. Screw the CIK assembly to the interior of the
opening (4 screws).
2
