58
Install Rocks & Shale 1714RSS
Material required
• Small container to distribute shale (not supplied)
• Rock & Shale Set, which contains:
◊ 1/2lb-bag of 3/4” grey shale
◊ 1/2lb-bag of 3/4” black shale
◊ 5 twigs
◊ 34 rocks
Installation
Carefully unpack the kit.
1. Mix the black and grey shale pieces and spread
them by hand in one layer thick on top of the burner.
Do not pour from the bag to avoid fi ne particles
blocking burner ports. Do not overfi ll!
NOTE:
Ensure the areas
within
the pilot shield, on
the pilot shield and in pilot safe zone are clear of
shale.
Do not put rocks on the pilot shield!
2. Place rocks around the shale bed as indicated.
These rocks will be used to support the twigs. The
rocks used is not important.
INSTALLATION
Pilot shield
Pilot safe zone
3. Place the twigs on the rocks as shown.
Note:
The position of the twigs are specifi c to obtain
the best fl ame pattern. The twigs should not rest fl at
on the shale bed. Their position across the shale
bed allows some air underneath.
a) Place the one of the curvy twigs as indicated.
b) Place a short Y twig on the rocks behind the
pilot shield; rest the other end on the shale bed.
QUALIFIED
INSTALLER
