Batteries
Owner’s Information
The appliance uses four 1.5 V AA batteries for its remote control receiver and one 9 V battery
for its handset. Batteries should last one to two seasons, depending on usage. Removing the
batteries in the off-season will extend the battery life. Should the batteries lose power, the control
may be operated by manually turning the control knob at the valve or by turning off the valve at
the switch.
To replace the batteries in the remote control receiver
, carefully pull the receiver off its
Velcro
attachments on the cross beam.
If you need to touch up the paint on your cast unit, use the Stove Bright by Forrest 1990 Satin
Black spray paint. Please note that it may be necessary to spray the entire cast piece.
If any attention is required for your appliance, contact your supplier quoting the model number.
It will be helpful if the appliance serial number can also be quoted. This number is on the rating
plate, which is attached to the unit. The replacement parts are shown at the end of this manual.
Please always quote the part number and description when requesting spare parts.
Servicing
Touch Up
Paint
Remote
Control
Operation
Your fireplace remote control helps you get the comfort, convenience and aesthetics you want from
your gas fireplace. The remote controls your fireplace in different ways.
IMPORTANT:
BEFORE YOU BEGIN, please note that on this system, the settings of time, temperature
and automatic ON/OFF
can only be programmed when the function display is flashing
. Be patient
when programming as it can take a few seconds to set.
NOTE:
Before using the remote control system for the first time
, the receiver and the
handset must be synchronized. See the section
Initial Remote Control Set-up
on page 23 in
this manual.
WARNING:
When the pilot is lit, the valve motor turns
automatically to maximum flame height.
Make sure that the MAN knob on the valve is in ON position.
Make sure that the switch on the valve is in the
I
position.
Press and hold the OFF and (large flame) buttons until you hear
a short acoustic signal. Release the buttons.
The acoustic signals will continue until the pilot lights. The remote
control will go automatically into TEMP mode. The flame will be at
maximum height until the remote control reads the temperature (factory
set) and will then adjust the flame accordingly.
You can put the remote in MAN manual mode, change the temperature
in TEMP mode or program your remote in TIMER mode as indicated in
the following sections.
1.
.
.
Press the (small flame) button to reduce the flame to pilot.
Press the OFF button to turn the pilot off.
Alternately, you can press the
O
button on the switch if you won’t use
your fireplace for a long period of time, if you cannot locate your remote
control handset or if you wish to change the batteries.
1.
.
Turning Your
Fireplace ON
Turning Your
Fireplace OFF
Summary of Contents for Madrona MF28EN
Page 32: ...32 Wiring Diagram...
