8
Time
Owner’s Information
Operation
Modes
STANDBY MODE—Ignited pilot only.
man
MAN MODE—Manual Mode. You can use this mode to adjust the flame height up or down.
☼
temp
TEMP MODE—Daytime Temperature Mode (appliance must be in Standby mode; pilot ignited):
The room temperature is measured and compared to the set temperature. The flame height is then
automatically adjusted to achieve the Daytime set temperature.
☽
temp
TEMP MODE—Nighttime Setback Temperature Mode (appliance must be in Standby mode,
pilot ignited): The room temperature is measured and compared to the Nighttime Setback temperature.
The flame height is then automatically adjusted to achieve the Nighttime Setback temperature.
timer
TIMER MODE—(appliance must be in Standby mode, pilot ignited): The Timer setting allows you
to set two burner ON times and two burner OFF times for every 24-hour period.
The flame height can be adjusted in the following manners. In STANDBY mode,
Press the (large flame) button to turn on the main burner.
Press the (large flame) button to increase the flame height.
Press the (small flame) button to decrease the flame height or to go to pilot Standby position.
For fine adjustments, tap the
and
buttons.
Quick Flame Adjustment
If or are pressed for 0.5 sec., the flame will increase to maximum or decrease to the pilot
Standby position.
NOTE: While pressing either button, a symbol indicating transmission appears on the upper right hand
corner of the display. The receiver confirms transmission with an acoustic signal.
1.
.
.
Changing the Mode of Operation
Briefly pressing the
SET
button changes the mode of operation in the following order:
man
→
☼
temp
→
☽
temp
→
timer
→
and back to
man
.
NOTE: MAN mode can also be reached by pressing either the or buttons.
Mode
Sun
☼
Moon
☽
TEMP
Daytime temperature setting
Nighttime temperature setting
TIMER
Start time setting
Stop time setting
Flame Height
To set the time, follow the steps below.
The display indicates °C/24-hour or °F/12-hour clock. To change from one
to the other, press and hold both the
OFF
and buttons until the display
changes.
To set the time, hold down
both
the and buttons until the display
flashes. Let go.
Quickly press the button to set the hour and the button to set the
minutes.
Note: You must start setting the time while the display is flashing. If it stops
flashing, go back to 2.
Press the
OFF
button to return to manual mode or simply wait and it will
automatically return to Manual mode.
1.
.
.
.
Summary of Contents for Madrona MF28EN
Page 32: ...32 Wiring Diagram...
