19
Appliance Preparation
3/8” gas line
connection
5/16”
fl
are
Fixing Casting Side Panels & Engine
1. Adjust the position of the engine to locate the top
and bottom screws of the side panels into the slots
of the engine’s side bracket. Tighten the top and
bottom screws.
2. Adjust the engine as required and
fi
x it to the casting
base at bottom of its side brackets with the nuts and
bolts provided.
Lighting Instructions Plate
The lighting instructions plate is attached to the back of
the engine and may have slid out of its slot. Reposition
the plate if this is the case.
Receiver hooked to burner pipes
Remote Control Receiver
Under the engine, the receiver box is clipped to the
burner pipes to facilitate transportation.
Unclip the box and let it hang while you
fi
t the gas pipe.
Gas Pipe & Connector
Fit the pipe and connector supplied with the engine to
the valve. Connect the gas line to the inlet pipe.
INSTALLATION
