1. Place the rear log centering it side to side in the
fi
rebox. Position forward until it sits against the
sheet metal return behind the burner.
2. Place the front left log on top of the burner with its
front edge resting slightly on the window frame.
3. Place the front right log on the top of the burner with
its left end abutted to the front left log and its front
edge resting slightly on the window frame.
Center the front logs side to side in relation to
the fi rebox.
Rear Log
against
Sheet Metal
Return
Both front logs to rest slightly on the
edge of the
fi
rebox window frame.
4. Identify the right cross log; it has
a hole under on of its end and it
is the shortest cross log. Place
it on the right pin located on the
rear log. Rest its other end in the
crook of the front right log.
5. Identify the middle cross log. It does not have a
hole underneath. Place its narrow end on the
fl
at
depression in the rear log next to the right cross log
on the rear log. Place its wider end on the front log.
6. Identify the left cross log; it has a hole under its
narrow end. Place its narrow end on the pin located
on the rear log. Rest its wider end on the the crook
in the front left log at an
angle of approximately 30
degrees from the center
line of the
fi
replace to allow
for the
fl
ame to come up in
front of the rear log.
23
Ceramic Logs Installation
Unpack the ceramic logs very carefully to avoid
damaging their fragile material. Install the logs as
shown below.
Please note that the position of the
logs is critical to insure the good performance of
the appliance.
INSTALLATION
