28
Owner’s Information
Dust can be brushed from the ceramic logs and
fi
rebox
walls after removing the front unit and opening the win-
dow. Dust can also be removed from the burner using
a soft brush after removing the ceramic logs. When
cleaning, make sure that no particles are brushed into
the slots of the burner.
Checks
A periodic check of the pilot and burner
fl
ames should
be made. Check after the
fi
re has been on for at least
30 minutes. The pilot
fl
ame must cover the tip of the
thermocouple probe. The main burner
fl
ame pattern will
vary from appliance to appliance depending on the type
of installation and climatic conditions.
The appliance area must always be kept clear and
free from combustible materials, gasoline and other
fl
ammable vapors and liquids.
Inspect the vent terminal outdoors regularly to make
sure that snow, trees, bushes, leaves, or other objects
do not obstruct it.
Examine the vent system and terminal regularly. We
recommend annually.
Batteries
Low battery signal: see page 34.
The appliance uses four 1.5 V AA alkaline batteries
for its remote control receiver and one 9 V alkaline
battery for its handset. Batteries should last one to two
seasons, depending on usage. Removing the batteries
in the off-season will extend the battery life. Should
the batteries lose power, the control may be operated
by manually turning the control knob at the valve or by
turning off the valve at the switch.
To replace the batteries in the remote control
receiver
, pull the clipped receiver off the cross beam,
replace the batteries and clip it back to the cross beam.
Touch Up Paint
If you need to touch up the paint on your cast unit, use
the Stove Bright by Forrest 1990 Satin Black spray
paint. Please note that it may be necessary to spray
the entire cast piece.
Lighting, Operation and Rating Information
The Lighting, Operation and Rating information is
located on the rear of the appliance casing.
To access the plate, reach over the top of the stove
and pull the plate out from its holder to read it. There is
important information on both sides of the plate.
CAUTION
To avoid short-circuit to the receiver, position the
antenna
so that it
DOES NOT TOUCH the ignition
wire.
CAUTION
DO NOT USE
a screwdriver or other metallic
object to remove the batteries from the battery box
or the handset! This could cause a short circuit.
WARNING
DO NOT ATTEMPT TO CHANGE THE BATTER-
IES WHILE THE FIREPLACE IS STILL HOT!
Let
the
fi
replace cool
fi
rst before touching it.
WARNING
DO NOT ATTEMPT TO TOUCH THE DATA PLATE
WHILE THE FIREPLACE IS STILL HOT!
Let the
fi
replace cool
fi
rst before touching it.
Correct Flame Picture
Thermocouple
probe must be
in flame
Pilot Flame can be
seen between logs
Pilot
fl
ame
OWNER’S INFO
