7
WARNING
DO NOT TOUCH THE BARRIER SCREEN OR
DO NOT TOUCH THE BARRIER SCREEN OR
FIREPLACE WHILE THEY ARE HOT!
FIREPLACE WHILE THEY ARE HOT!
Let the
Let the
fi replace cool fi rst before cleaning it.
fi replace cool fi rst before cleaning it.
FOR SAFETY PURPOSE, ensure the barrier
FOR SAFETY PURPOSE, ensure the barrier
screen is re-installed on the fi replace front after
screen is re-installed on the fi replace front after
maintenance if it has been removed.
maintenance if it has been removed.
WARNING
!
Top Casting
Place the top casting piece on the top of the stove
ensuring the rear edge is fl ush with the rear edge of
the cast side panels. Fill in the vent space with the
infi ll plate if using a rear vent. To level the top casting,
unscrew the levelling bolts on the top rear of each
casting side panel as appropriate.
Removeable Fret
(Arched Front only)
To access the gas valve and the remote control
receiver, the fret can be removed without removing the
front casting. Once
the stove has cooled down and
with extra care not to hit the glass of the window,
simply slide up the fret out of its brackets, angle it up
and remove it. To put it back in place, proceed in the
reverse order.
Barrier Screen
(Arched Front only)
Install the barrier screen to the front of the Madrona
stove.
1. Insert the top clip in the top of the opening of the
cast front.
2. Push the sides of the screen against the front so
the side clips hook to the front.
Maintenance
Cast iron stove body
The matte cast body (MFCS01) can be cleaned with
a soft brush. The enamel cast body (MFCS02) can be
cleaned with a damp soft lint-free cloth.
Barrier screen
Remove the barrier screen by pulling the top fi rst then
the bottom. Dust down using a brush.
If the barrier becomes damaged, the barrier shall
be replaced with the manufacturer’s barrier for this
appliance.
Window and fi replace
NOTE: DO NOT use amonia cleaner for the
fi replace window.
See the
Owner’s Information
section in the Madrona
MF28I fi replace Owner’s Manual for instructions on
cleaning the window and fuel bed.
Hooks (2)
Fret Mounting
Brackets (2)
2
1
2
