11 of 19
10.
REMOTE CONTROL INSTALLATION
Caution! Don’t connect the batteries to the remote control receiver until the wires are
connected to the burner control unit, as short circuit could result in destruction of the
electrical components.
When installing the remote please refer to figures 10 and 11.
•
Connect the wiring harness to the receiver box, by pushing the wire connector on to the receiver circuit
board. The plug will only go on one way so please ensure that the wires are pointing up and slot in the
board is inline with the tab on the wiring harness plug, see fig 11.
•
Connect wires as shown in fig 11 - Please note that the connectors are different sizes, the smaller one fits
to the lower connection on the valve.
•
Remove the remote control receiver lid.
•
Fit four 1.5V batteries.
•
Place the remote control receiver on the “Velcro” pad, see fig 10.
•
Fit the 9V battery to the handset transmitter
Remote control operating instructions are on page 17 of this manual and are supplied with the remote
control kit.
Figure 11 Valve connections
Figure 10
