General notes regarding conversion
The conversion may be done before or after the
appliance is installed into the cavity. However, the
gas must be connected in order to set the manifold
pressure.
Prepare the appliance
1. If the fi replace is already installed, remove the front,
window and fuel bed.
2. Disconnect the gas inlet pipe from the inlet elbow
fi tting on the valve.
Conversion procedure
1. Detach the burner module (11 screws).
2. Disconnect the burner elbow injector from the pipe,
using a 11/16” (17 mm) wrench.
3. Remove the screw securing the pilot bracket to the
burner support bracket.
4. Detach the burner unit from the burner plate (4 screws).
Disconnect
5. Detach the two burner support brackets from the
burner rail (2 nuts).
6. Disconnect the pilot unit and shield from its bracket
(2 screws).
7. Accessing pilot assembly from underside of module,
disconnect the pilot pipe, using a 7/16” (11 mm)
wrench.
8. Remove the pilot injector. Replace by the
appropriate pilot injector—see the Specifi cations
table on the fi rst page.
9. Replace the main burner with the burner assembly
supplied and reassemble the module.
Note - The pilot
injector should
be slipped onto
the end of the
pipe from the
side. The pilot
pipe, with injector
attached, should
be inserted into
the assembly.
Burner module rear view
2
© Copyright Miles Industries Ltd., 2013.
