Valor Retrofire RF24XBN, Installation Manual And User'S Manual

23

Window Re



 tting and Checking

Hook the window over the top edge of the 



 rebox, and 

fasten the bottom two spring loaded bolts by pushing in 
and turning 90 degrees. 

If the Hot Glass Warning plate has been removed 
from the front lower corner of the window, reinstall 
it by sliding it between the glass and the frame as 
indicated.

Note: To remove the window, the optional bottom 
cover or the cast iron fret and fret retainers as well 
as the screen will need to be removed 



 rst——see 

sections 

Optional Cast Iron Fret Installation

 or 

Optional Bottom Cover Installation

.

Spring-loaded

Fastening Studs (2)

1/4 Turn

Remote Control Installation

1.  Connect the wiring harness to the receiver box, by pushing the wire connector on to the 

receiver circuit board. The plug will only go on one way so please ensure that the wires 
are pointing up and slot in the board is in line with the tab on the wiring harness plug.

2.  Connect wires as shown. Please note that the ““L”” connectors are different sizes, the smaller one 



 ts to the 

lower connection and the larger one the top connection on the top left hand side of the valve. The other two wire 
connectors can be 



 tted to either terminal located to the left of the 



 ame control button.

3.  Remove the remote control receiver lid.
4.  Fit four AA 1.5 V alkaline batteries.
5.  Place the remote control receiver on the base 

of the 



 replace beside the valve.

6.  Fit the 9 V alkaline battery to the handset 

transmitter.

Remote control operating instructions are on 
pages 9––10 of this manual.

Remote Receiver

Receiver

GV34 Valve

Push-on

Connector

CAUTION

DO NOT PUT BATTERIES IN THE REMOTE CONTROL RECEIVER until the 
wires are connected to the burner control unit as short-circuit could result 
in the destruction of the electrical components.

CAUTION

DO NOT USE

 a screwdriver or other metallic object to remove the batteries from the 

receiver or the handset! This could cause a short circuit to the receiver.

Hot Glass Plate

QUALIFIED 
INSTALLER