Valor Retrofire RF24XBN, Installation Manual And User'S Manual

OWNER’’S 
INFORMATION

9

Remote Control Operation

Your 



 replace remote control helps you get the comfort, convenience and aesthetics 

you want from your gas 



 replace. The remote controls your 



 replace in different 

ways. 

IMPORTANT:

BEFORE YOU BEGIN, please note that on this system, the settings 

of time, temperature and automatic ON/OFF 

can only be programmed when the 

function display is 

fl

 ashing

. Be patient when programming as it can take a few 

seconds to set.

Setting the time

The 



 rst thing to do is to set the time.

1.  With your thumb, hold down 

both

 the 

AUTO

 and 

TIMER

 buttons until 

F



 ashes. 

Let go.

2.  Note the digital clock on the bottom right hand corner. The 

Ÿ

 button sets the 

hour; the 

ź

button sets the minutes. Set the time.

Note: You must start setting the time while the 

F

 is 



 ashing. If it stops 



 ashing, 

go back to 1.

3.  The display shows °C/24-hour or °F/12-hour. To change the temperature/hour 

display, press on the 

AUTO

 button while the display 



 ashes.

4.  Let go and wait until the 



 ashing stops. The remote shows the time you set. It 

also shows the current temperature.

Setting the temperature

Use this setting when you come in and want to enjoy a speci



 c temperature.

1.  Push the 

AUTO

 button until a number and 

F



 ash. Let go.

2.  While it is still 



 ashing, push the 

Ÿ

 and 

ź

 buttons to the temperature you want. 

Let go.

Your 



 replace will reach that temperature and the remote will check the temperature 

every 



 ve minutes, adjusting the amount of fuel needed to give you a steady, even heat.

Setting the 



 ame

Use this setting when you want a particular 



 ame level. For instance, you want to 

watch 



 ames burn at their highest level and you don’’t mind if the room is too hot.

1.  To raise the 



 ame, press and hold the 

Ÿ

 button until the flame gets to the 

desired level. Let go.

2.  To lower the 



 ame, press and hold the 

ź

 button until the 



 ame gets to the 

desired level. Let go.

The 



 ame level

 will remain just as you set it.