EN-18
Valor™ 7000
Series
4.7 Print1 Menu
Enter this menu to set printing parameters. Default settings are
bold
.
Note:
The Print2 menu is only displayed if a second interface is installed.
Reset
[
reset
]
Reset the Print menu to factory defaults.
NO
= no reset
YES
= reset
Stable Only
[
Stable
]
Set the printing criteria.
OFF
= values are printed immediately
ON
= values are only printed when the stability criteria are met
Auto Print
[
A.Print
]
Set the automatic printing functionality.
OFF
= disabled
ON.STAB
= printing occurs each time the stability criteria are met
1
INTER
= printing occurs at the defined interval
2
CONT
= printing occurs continuously
ACCEPT
= printing occurs each time the display is within the Checkweigh accept
range and stability criteria are met.
1
When ON.STAB is selected, set the condition for printing, where:
LOAD
= printing occurs when the load is stable and greater than zero
LOAD.ZR
= printing occurs when any load is stable and equal to or greater
than zero.
2
When INTER is selected, set the Print Interval.
1 to 3600 (seconds)
Reset:
no
, yes
Stable Only:
off
, on
Auto Print:
off
, on stable, interval, continuous, accept
Content:
Result (-> off,
on
)
Gross (->
off
, on)
Net (->
off
, on)
Tare (->
off
, on)
Header (->
off
, on)
Footer (->
off
, on)
Mode (->
off
, on)
Unit (-> off,
on
)
Info (->
off
, on)
Accu (->
off
, result, all)
Layout:
Format (->
S
,M)
Feed (->
Line
, 4 Lines, form)
Data Transfer:
off
, on
End Print:
Exit menu
