MOUNTING THE CAMERA
1) Please make sure that you are following the regulations and laws set by your Country or
states DMV (Department of Motor Vehicles) prior to mounting your camera. This will avoid
any accidents and traffic violations that can occur if the camera is mounted in a location that
is prohibited by law.
2) Using the suction cup and rotating bracket, mount the Wi-Fi Action Camera to the inside of
your vehicles windshield (use the adjustment knob to loosen and tighten the Wi-Fi Action
Camera as needed).
NOTE
: The Wi-Fi Action Camera can also be used to record both exterior and interior (front
and rear) of your vehicle. For interior recording, simply follow the steps above and rotate the
camera so that the lens is facing the inside of your vehicle.
INSERT THE SD CARD
Insert your micro SD card into the Wi-Fi Action Camera’s micro SD slot. Make sure that you
insert the in the correct direction as shown. The SD card will make a clicking sound, indicating
it has been locked into the Carcam.
CONNECT THE POWER CABLE
1) Connect the car chargers cable into the Wi-Fi Action Camera’s power socket located on
the bottom side of the Carcam.
WIFI
SOS