Service and Installation Manual
For warranty service, call 1-888-VALPRO8 / 1-813-502-030
26
Troubleshooting
Before Calling for Service
If the unit appears to be malfunctioning, read through the OPERATION
section of this manual first. If the problem persists, check the Troubleshooting
Guide below and on the following page. The problem may be something very
simple that can be solved without a service call.
Troubleshooting Guide
Problem
Possible Cause
Probable Correction
The machine
doesn't
operate
The ice maker is
unplugged.
Plug the ice maker in.
The fuse is blown.
Replace fuse--if it happen, call for
service to check for a short circuit
in the ice maker.
The ice storage bin is
full of ice.
Take away some ice, make the
ice-full sensor is free of ice.
The water
doesn't feed
in after the
ice maker
starts.
The water supply tap is
turn off.
Turn on the water supply tap.
The water supply pipe
is not proper connected.
Reconnect the water supply pipe.
Machine
makes ice,
but bin does
not fill up
with ice
The condenser may be
dirty.
Clean the condenser.
The air flow to the ice
maker may be
obstructed.
Check the installation.
The ambient
temperature and water
temperature are high, or
it is near with some heat
resource.
Check the installation.
Water is
leaking out
the unit.
A few water drops to
the floor when you
open the door to take
out ice from ice storage
bin.
Normal condensation on the door
or some water together with ice.
Take care when you take out ice.
Water supply
connection leaks.
Tighten fitting. See Connecting the
water line.
Service and Installation Manual
3
For warranty service, call 1-888-VALPRO8 / 1-813-502-030
IMPORTANT SAFEGUARDS
Before the ice maker is used, it must be properly
positioned and installed as described in this manual, so
read the manual carefully. we strongly recommends
that you have a professional install your new machine.
The warranty may be affected or voided by an incorrect
installation. To reduce the risk of fire, electrical shock
or injury when using the ice maker, follow basic
precautions, including the following:
It is recommended that a separate circuit, serving only your ice maker, be
provided. Use receptacles that cannot be turned off by a switch or pull chain.
•
Do not connect or disconnect the electric plug when your hands are wet.
•
Never unplug the ice maker by pulling on the power cord. Always grip the
plug firmly and pull straight out from the outlet.
•
Never clean ice maker parts with flammable fluids. Do not store or use
gasoline or other flammable vapors and liquids in the vicinity of this or any
other appliance. The fumes can create a fire hazard or explosion.
•
Before proceeding with cleaning and maintenance operations, make sure the
power line of the unit is disconnected and the water line is shut off.
(EXCEPTION: When cleaning the machine’s ice making and water systems,
see pages 23 – 26.)
•
Before operating, put all the enclosure panels back into their original place.
•
Do not touch the evaporator with your hand when the machine is operating.
•
Unplug the ice maker or disconnect power before cleaning or servicing.
Failure to do so can result in electrical shock or death.
•
Do not attempt to repair or replace any part of your ice maker unless it is
specifically recommended in this manual. All other servicing should be
done by a qualified technician.
Summary of Contents for VPIM-420
Page 2: ......
