SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE
8
BATTERY INSTALLATION
MAINTENANCE
ATTENTION: Disconnect all plugs from the panel, and
the cable of the spark plug if the motor is of electrical
starting, before any inspection for maintenance.
3
4
5
1
2
CAUTION
Before installing the battery, remove the key from
the Control Panel of your generator.
Set the battery holder on the frame and secure it with the
screw, washer and nut as shown in the drawing.
Place the battery on the battery holder.
Secure the battery using the brackets attach on the
battery holder.
Identify the red and black wires with positive and negative
electrodes of the battery.
Connect the red wire to the positive terminal of the
battery and the black wire to the negative terminal.
(See Fig.
Handle the battery carefully as it contains highly corrosive
acid and can cause burns. Never connect the red wire to
black, this can cause damage to physical integrity and
the equipment.
GENERATOR CONTROLS
The ligth must be turn off when
the engine is running.
Choke
Fuel valve
Key switch and oil pressure
indicator light
CONTROL PANEL
Hourmeter
Circuit breaker
Voltmeter
Idle control switch
120 VAC surge
120/240 VAC surge
Summary of Contents for G120MG2200RV
