Valtra N103 H3, Service Manual

•

When using a cold grease remover, do not keep the

tractor in sunshine.
The paint work may get damaged, if the painted

surface is hot.

•

Wax the painted surfaces.

After you finish:

After washing, grease the lubricating points and the

joints and lubricate the bearings with oil.

Cleaning the engine compartment
Keep the engine surface clean to avoid the risk of fire.
NOTE: Protect the environment by following the

environmental regulations. The washing place must

have a separator outlet when using detergents.

•

Let the engine cool down for a few minutes before

washing.
IMPORTANT: To avoid the risk of fire, do not wash

the engine when it is hot.

•

Wash the engine carefully using pressure washer.
Keep the nozzle of the pressure washer at least 30

cm from the sealing points and paint work. The

temperature of the washing water must not be

higher than 50°C.
•

Use lower pressure, 6.5 MPa / 65 bar.

•

Point the water jet diagonally to the engine.

NOTE: Do not use special nozzles, such as turbo

nozzles, when washing. Follow the instructions of

the pressure washer manufacturer.

•

Do not use high pressure to wash the electric and

fuel equipment or the radiator.
These components can be damaged easily. Wash

the delicate engine parts by hand.

•

Let the engine dry up before starting.

Cleaning polycarbonate windows
The polycarbonate windows must be cleaned regularly

to keep the windows bright as long as possible.

•

Wash the windows by hand or pressure washer.
NOTE: Do not use special nozzles, such as turbo

nozzles, when washing. Follow the instructions of

the pressure washer manufacturer.
Do not point the pressure washer towards the side

seals or lead-through seals. The possible detergent

may reach the glass parts which are not coated.

•

Wipe the stains by using a detergent or plenty of

water.
The coated parts of the windows withstand different

detergents well.
NOTE: Do not use abrasive detergents and do not

rub the windows dry.

•

Do not use the window wiper on a dry window.
Ensure that there is enough fluid in the washer

reservoir.

•

Never clean the polycarbonate windows using a

sharp tool like an ice scraper.

Greasing lubricating points fitted with grease nipples
1. Always clean the grease nipples before applying

the grease gun.

2. Apply grease through the nipples until clean grease

oozes out (unless otherwise instructed).
NOTE: Preferably carry out lubrication with bearing

points and joints unloaded and with the bearings in

different positions.

3. Wipe away superfluous grease which has been

pressed out at the lubricating point.

13. Maintenance

Model

N3 HiTech 3PS

Code

131.1

Page

3

22.8.2013