IMPORTANT: Make sure that the joint shaft angles are not exceeded.
IMPORTANT: Do not exceed the maximum output durability of the PTO shaft.
•
Make sure that the length of the PTO drive shaft is correct for the PTO-driven
implements to be used.
The shaft must be able to work at full deflection vertically and horizontally.
IMPORTANT: A shaft that is too long can cause damage.
•
Attach the PTO-driven implement to the tractor.
IMPORTANT: Attach the implement to the tractor before connecting the
power take-off (PTO) drive shaft between the tractor and the implement.
Otherwise, the implement can start to rotate with the PTO drive shaft.
•
Install the PTO drive shaft according to the manufacturer's instructions.
DANGER: When fastening the power take-off (PTO) drive shaft
between the tractor and the implement, check that its guard is
undamaged. Attach the guard to a stationary part of the tractor
frame or implement.
•
Engage the PTO at a low engine speed to protect the PTO.
•
In freezing weather, ensure that the transmission oil is warm before engaging
the PTO.
Before engaging the PTO in freezing weather:
•
let the engine and transmission oil warm up for a little while at low engine
revs. To speed up the transmission oil warming, adjust the engine speed
to 1 500 rpm and keep the steering wheel turned to the extreme position.
•
When engaging the PTO and the attached implement allows it, wait
approximately 5 seconds until the clutch of the PTO shaft is totally engaged
before loading it.
3.19.2
Rear power take-off
You can use power take-off (PTO) to transmit power from the tractor to an
implement.
The PTO shaft is a splined driveshaft that is easily connected and disconnected.
The rear power take-off controls are the following:
3. Operation
- 265 -
Summary of Contents for Versu N Series
Page 1: ...OPERATOR SMANUAL NSERIES Versu Ref no 39 893 21 3 08 2015 YOUR WORKING MACHINE...
Page 2: ......
Page 517: ......
